800G OSFP SR8 Transceiver
F-tone Networks 800G OSFP SR8 Transceiver. Application • Data center & Networking Equipment; Features • Hot-pluggable OSFP 800G SR8 multimode transceiver; Pr…
- Application
- • Data center & Networking Equipment
- Features
- • Hot-pluggable OSFP 800G SR8 multimode transceiver
- Product Specification
- Absolute Maximum Ratings (TC=25 °C, unless otherwise noted)
- Notes
- Average launch power, each lane (min) is informative and not the principal indicator of signal strength.
- PIN Descriptions
- Figure 1 – OSFP module Pinout
- Mechanical Specifications
- Figure 2 – Mechanical Dimensions
Reference model FW-087-800G-OSFP-SR8-TRANSCEIVER in your inquiry. Datasheets are confirmed offline before order. Full specifications ↓
Technical parameters
| Application | • Data center & Networking Equipment |
|---|---|
| Features | • Hot-pluggable OSFP 800G SR8 multimode transceiver |
| Product Specification | Absolute Maximum Ratings (TC=25 °C, unless otherwise noted) |
| Notes | Average launch power, each lane (min) is informative and not the principal indicator of signal strength. |
| PIN Descriptions | Figure 1 – OSFP module Pinout |
| Mechanical Specifications | Figure 2 – Mechanical Dimensions |
| ESD Safety Cautions | This transceiver is specified as ESD threshold 1KV for high speed data pins based on Human Body Model per ANSI/ESDA/JEDECJS-001. The units are subjected to 15kV air discharges during operation and 8kV direct contact discharges to the case. However, normal ESD precautions are still required during the handling of this module. This transceiver is shipped in ESD protective packaging. It should be removed from the packaging and handled only in an ESD protected environment. |
| Important Notice | The performance figures, data, and any illustrative material presented in this datasheet are typical and must be explicitly confirmed in writing by before they are deemed applicable to any specific order or contract. |
| Model | 800G OSFP SR8 Transceiver |
Product details
• Hot-pluggable OSFP 800G SR8 multimode transceiver • Compliant with OSFP MSA Type2 flat top with dual MPO-12 connector • Compliant with CMIS Rev 5.0 and above revision • Maximum power consumption 17W
Official English source features include: •; Hot-pluggable OSFP 800G SR8 multimode transceiver; •; Compliant with OSFP MSA Type2 flat top with dual MPO-12 connector; •; Compliant with CMIS Rev 5.0 and above revision; •; Maximum power consumption 17W; •; Dual MPO-12 APC receptacles; •; Up to 30m reach on OM3 and 50m on OM4; •; Case operating temperature 0.
Applications listed on the official English page: •; Data center & Networking Equipment; •.
Parameters and any table below are taken from the official English source page and are typical values only. The inquiry code on this page is an inquiry code, not a confirmed factory part number.
| Parameter | Symbol | Min | Typical | Max | Unit | Notes |
|---|---|---|---|---|---|---|
| Storage Temperature | TS | -40 | - | +85 | °C | |
| Maximum Supply Voltage | Vcc | -0.5 | - | 3.6 | V | |
| Operating Relative Humidity | RH | 5 | - | 95 | % | No condensation |
| Control Input Voltage | V I | -0.3 | - | V CC +0.5 | V |
| Parameter | Symbol | Min | Typical | Max | Unit | Notes |
|---|---|---|---|---|---|---|
| Operating Case Temperature | T OPR | 0 | - | 70 | °C | |
| Power Supply Voltage | V CC | 3.135 | 3.3 | 3.465 | V | |
| Instantaneous peak current at hotplug | I CC_IP | - | - | 6800 | mA | |
| Sustained peak current at hot plug | I CC_SP | - | - | 5670 | mA | |
| Maximum Power Dissipation | P D | - | - | 17 | W | |
| Maximum Power Dissipation, LowPower Mode | P DLP | - | - | 1.5 | W | |
| Signaling Rate per Lane | SRL | - | 53.125 | - | GBd | PAM4 |
| Two Wire Serial Interface ClockRate | - | -100 | - | 1000 | kHz | |
| Power Supply Noise Tolerance (10Hz - 10MHz) | - | - | - | 66 | mV | |
| Rx Differential Data Output Load | - | - | 100 | - | Ohm | |
| Operating Distance (OM3) | - | 2 | - | 30 | m | |
| Operating Distance (OM4) | - | 2 | - | 50 | m |
| Parameter | Symbol | Min | Typical | Max | Unit | Notes |
|---|---|---|---|---|---|---|
| Operating Case Temperature | T OPR | 0 | - | 70 | °C | |
| Power Supply Voltage | V CC | 3.135 | 3.3 | 3.465 | V | |
| Instantaneous peak current at hotplug | I CC_IP | - | - | 6800 | mA | |
| Sustained peak current at hot plug | I CC_SP | - | - | 5670 | mA | |
| Maximum Power Dissipation | P D | - | - | 17 | W | |
| Maximum Power Dissipation, Low Power Mode | P DLP | - | - | 1.5 | W | |
| Signaling Rate per Lane | SRL | - | 53.125 | - | GBd | PAM4 |
| Two Wire Serial Interface ClockRate | - | -100 | - | 1000 | kHz | |
| Power Supply Noise Tolerance(10Hz - 10MHz) | - | - | - | 66 | mV | |
| Rx Differential Data Output Load | - | - | 100 | - | Ohm | |
| Operating Distance (OM3) | - | 2 | - | 30 | m | |
| Operating Distance (OM4) | - | 2 | - | 50 | m |
| Parameter | Symbol | Min | Typical | Max | Unit | Notes |
|---|---|---|---|---|---|---|
| Wavelength | λ C | 844 | 850 | 863 | nm | |
| RMS spectral width | ∆λ rms | 0.6 | nm | |||
| Average Launch Power, each lane | AOP L | -1.0 | - | 3.0 | dBm | 1 |
| Outer Optical Modulation Amplitude (OMA outer ), each lane | T OMA | -2.1 | 3.5 | dBm | 2 | |
| Transmitter and Dispersion Eye Closure for PAM4 (TDECQ), each lane | TDECQ | - | - | 4.4 | dB | |
| Average Launch Power of OFF Transmitter, each lane | T OFF | - | - | -30 | dBm | |
| Extinction Ratio, each lane | ER | 2.5 | 3.5 | - | dB | |
| RIN 14 OMA | RIN | - | - | -148 | dB/Hz | |
| Optical Return Loss Tolerance | ORL | - | 14 | dB | ||
| Transmitter Reflectance | T R | - | - | -26 | dB | 3 |
| PIN | Logic | Symbol | Name/Description |
|---|---|---|---|
| 1 | GND | Ground | |
| 2 | CML-I | TX2p | Transmitter Data Non-Inverted |
| 3 | CML-I | TX2n | Transmitter Data Inverted |
| 4 | GND | Ground | |
| 5 | CML-I | TX4p | Transmitter Data Non-Inverted |
| 6 | CML-I | TX4n | Transmitter Data Inverted |
| 7 | GND | Ground | |
| 8 | CML-I | TX6p | Transmitter Data Non-Inverted |
| 9 | CML-I | TX6n | Transmitter Data Inverted |
| 10 | GND | Ground | |
| 11 | CML-I | TX8p | Transmitter Data Non-Inverted |
| 12 | CML-I | TX8n | Transmitter Data Inverted |
| 13 | GND | Ground | |
| 14 | LVCMOS-I/O | SCL | 2-wire Serial interface clock |
| 15 | VCC | +3.3V Power | |
| 16 | VCC | +3.3V Power | |
| 17 | Multi-Level | LPWn/PRSn | Low-Power Mode / Module Present |
| 18 | GND | Ground | |
| 19 | CML-O | RX7n | Receiver Data Inverted |
| 20 | CML-O | RX7p | Receiver Data Non-Inverted |
| 21 | GND | Ground | |
| 22 | CML-O | RX5n | Receiver Data Inverted |
| 23 | CML-O | RX5p | Receiver Data Non-Inverted |
| 24 | GND | Ground | |
| 25 | CML-O | RX3n | Receiver Data Inverted |
| 26 | CML-O | RX3p | Receiver Data Non-Inverted |
| 27 | GND | Ground | |
| 28 | CML-O | RX1n | Receiver Data Inverted |
| 29 | CML-O | RX1p | Receiver Data Non-Inverted |
| 30 | GND | Ground | |
| 31 | GND | Ground | |
| 32 | CML-O | RX2p | Receiver Data Non-Inverted |
| 33 | CML-O | RX2n | Receiver Data Inverted |
| 34 | GND | Ground | |
| 35 | CML-O | RX4p | Receiver Data Non-Inverted |
| 36 | CML-O | RX4n | Receiver Data Inverted |
| 37 | GND | Ground | |
| 38 | CML-O | RX6p | Receiver Data Non-Inverted |
| 39 | CML-O | RX6n | Receiver Data Inverted |
| 40 | GND | Ground | |
| 41 | CML-O | RX8p | Receiver Data Non-Inverted |
| 42 | CML-O | RX8n | Receiver Data Inverted |
| 43 | GND | Ground | |
| 44 | Multi-Level | INT/RSTn | Module Interrupt / Module Reset |
| 45 | VCC | +3.3V Power | |
| 46 | VCC | +3.3V Power | |
| 47 | LVCMOS-I/O | SDA | 2-wire Serial interface data |
| 48 | GND | Ground | |
| 49 | CML-I | TX7n | Transmitter Data Inverted |
| 50 | CML-I | TX7p | Transmitter Data Non-Inverted |
| 51 | GND | Ground | |
| 52 | CML-I | TX5n | Transmitter Data Inverted |
| 53 | CML-I | TX5p | Transmitter Data Non-Inverted |
| 54 | GND | Ground | |
| 55 | CML-I | TX3n | Transmitter Data Inverted |
| 56 | CML-I | TX3p | Transmitter Data Non-Inverted |
|---|---|---|---|
| 57 | GND | Ground | |
| 58 | CML-I | TX1n | Transmitter Data Inverted |
| 59 | CML-I | TX1p | Transmitter Data Non-Inverted |
| 60 | GND | Ground |
| Data Rate | Factor | Optical | Wavelength | Reach | |
|---|---|---|---|---|---|
| 800G | OSFP | SR8 | MPO | 850nm | 70m |
| Rev. | Comments | Author | Date |
|---|---|---|---|
| A01 | Initial Release | James Chen | 10/01/2023 |
FW-087 Product Notice
This product belongs to the F-tone Networks FW-087 series. For detailed information, please contact our sales team.
Important Notice
Performance figures, data and any illustrative material provided on this page are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement, specifications may change without notice.
The publication of information on this page does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.
Contact Us
For pricing, datasheets and OEM/ODM inquiries, contact the F-tone Networks sales team: betty@f-tone.com / una@f-tone.com · WhatsApp: +86 17360698946 (Betty), +86 17761163895 (Una)
More in Optical Transceivers
MTP-16 OS2 Elite Trunk, 16 Fibres, 1m
View details →800G OSFP224 Passive Twinax DAC, 1m
View details →
MTP-12 OS2 Elite Trunk, 12 Fibres, 1m
View details →MTP-16 OM4 Elite Trunk, 16 Fibres, 1m
View details →
MTP-12 OM4 Trunk Cable, 12 Fibres, 1m
View details →MTP-12 APC OM4 Trunk, 12 Fibres, 1m
View details →
MTP to 4× LC UPC OM4 Breakout, 8F, 1m
View details →MTP to 4× LC UPC OS2 Breakout, 8F, 1m
View details →MTP to 12× SC UPC OS2 Breakout, 24F, 1m
View details →MTP to 12× LC UPC OS2 Breakout, 24F, 1m
View details →MTP to 12× SC UPC OM4 Breakout, 24F, 1m
View details →MTP to 12× LC UPC OM4 Breakout, 24F, 1m
View details →MPO-8 APC OS2 Elite Trunk, 8 Fibres, 1m
View details →