Product image coming soon
MODEL · FW-087-200G-QSFP56-SR4-TRANSCEIVER

200G QSFP56 SR4 Transceiver

F-tone Networks 200G QSFP56 SR4 Transceiver. Application • Data center & Networking Equipment; Standards Compliance • IEEE 802.3bs, IEEE 802.3cd; • Sff 8679…

Application
• Data center & Networking Equipment
Standards Compliance
• IEEE 802.3bs, IEEE 802.3cd
• Sff 8679
• CMIS4.0 or SFF8636
Features
• Data rate up to 212.5Gbps (4x PAM4 53Gbps)
Product Specification
Absolute Maximum Ratings (TC=25°C, unless otherwise noted)
PIN Descriptions
Figure 1 – Pin Definitions

Reference model FW-087-200G-QSFP56-SR4-TRANSCEIVER in your inquiry. Datasheets are confirmed offline before order. Full specifications ↓

Specifications

Technical parameters

Application• Data center & Networking Equipment
Standards Compliance• IEEE 802.3bs, IEEE 802.3cd
• Sff 8679• CMIS4.0 or SFF8636
Features• Data rate up to 212.5Gbps (4x PAM4 53Gbps)
Product SpecificationAbsolute Maximum Ratings (TC=25°C, unless otherwise noted)
PIN DescriptionsFigure 1 – Pin Definitions
Optical CharacteristicsNotes: [1] Measured at TP3 for BER 2.4E-4 Pre-FEC
Module Memory MapFigure 2 –Memory Map
Optical Interface Lanes And AssignmentFigure 3 –Optical lanes Assignment
Mechanical SpecificationsUnit: mm
ESD Safety CautionsThis transceiver is specified as ESD threshold 1KV for high speed data pins and 2KV for all others electrical input pins, tested per MIL-STD-883, Method 3015.4 /JESD22-A114-A (HBM). However, normal ESD precautions are still required during the handling of this module. This transceiver is shipped in ESD protective packaging. It should be removed from the packaging and handled only in an ESD protected environment.
Important NoticeThe performance figures, data, and any illustrative material presented in this datasheet are typical and must be explicitly confirmed in writing by before they are deemed applicable to any specific order or contract.
Notes[1] Circuit ground is internally isolated from chassis ground.
Unitmm
Model200G QSFP56 SR4 Transceiver
Overview

Product details

• Data center & Networking Equipment • Servers/Storage Devices • High Performance Computing (HPC) • Switches/Routers • Telecom Central Offices (CO)

Official English source features include: • Data rate up to 212.5Gbps (4x PAM4 53Gbps); • Reach up to 70m on MMF(OM3); • Reach up to 100m on MMF(OM4); • 850nm VCSEL laser and PIN receiver; • High speed I/O electrical interface (200GAUI-4); • I2C interface with integrated Digital Diagnostic monitoring; • Single MPO-12 receptacle; • Single +3.3V power supply; • Power consumption <5 W; • Operating case temperature: 0 to +70°C; • Compliant to RoHS-10.

Applications listed on the official English page: • Data center & Networking Equipment; • Servers/Storage Devices; • High Performance Computing (HPC); • Switches/Routers; • Telecom Central Offices (CO); • Test and Measurement Equipment.

Parameters and any table below are taken from the official English source page and are typical values only. The inquiry code on this page is an inquiry code, not a confirmed factory part number.

Official English source table
ParameterSymbolMinTypicalMaxUnit
Storage TemperatureTS-40-+85°C
Maximum Supply VoltageVcc-0.5-4.0V
Operating Relative HumidityRH15-+85%
Official English source table
ParameterSymbolMinTypicalMaxUnitNotes
Operating Case TemperatureTc0-70oC
Power Supply VoltageVcc3.133.33.47V
Power Supply CurrentIcc--1.5A
Maximum Power DissipationPD--5W
Lane Baud RateBRLANE26.5625GBd
Transmission DistanceTD-70mOver MMF OM3
Transmission DistanceTD-100mOver MMF OM4
Official English source table
PinSymbolName/DescriptionRef.
1GNDGround1
2Tx2nTransmitter Inverted Data Input
3Tx2pTransmitter Non-Inverted Data Input
4GNDGround1
5Tx4nTransmitter Inverted Data Input
6Tx4pTransmitter Non-Inverted Data Input
7GNDGround1
8ModSelLModule Select
9ResetLModule Reset
10Vcc Rx+3.3 V Power supply receiver
11SCL2-wire serial interface clock
12SDA2-wire serial interface data
13GNDGround1
14Rx3pReceiver Non-Inverted Data Output
15Rx3nReceiver Inverted Data Output
16GNDGround1
17Rx1pReceiver Non-Inverted Data Output
18Rx1nReceiver Inverted Data Output
19GNDGround1
Official English source table
PinSymbolName/DescriptionRef.
20GNDGround1
21Rx2nReceiver Inverted Data Output
22Rx2pReceiver Non-Inverted Data Output
23GNDGround1
24Rx4nReceiver Inverted Data Output
25Rx4pReceiver Non-Inverted Data Output
26GNDGround1
27ModPrsLModule Present
28IntLInterrupt
29Vcc Tx+3.3 V Power supply transmitter
30Vcc1+3.3 V Power Supply
31LPModeLow Power Mode
32GNDGround1
33Tx3pTransmitter Non-Inverted Data Input
34Tx3nTransmitter Inverted Data Input
35GNDGround1
36Tx1pTransmitter Non-Inverted Data Input
37Tx1nTransmitter Inverted Data Input
38GNDGround1
Official English source table
ParameterMinTypicalMaxUnits
Receiver electrical output characteristics at TP4
Signaling rate per lane26.5625GBd
AC common-mode output voltage(RMS)-17.5mV
Differential peak-to-peak output voltage900mV
Near-end ESMW (Eye symmetry mask width)0.265UI
Near-end Eye height, differential70mV
Far-end ESMW (Eye symmetry mask width)0.2UI
Far-end Eye height, differential30mV
Far-end pre-cursor ISI ratio-4.52.5%
Official English source table
Differential termination mismatch10%
Transition time (min, 20% to 80%)9.5ps
DC common mode voltage-3502850mV
Transmitter electrical input characteristics at TP1
Signaling rate, per lane26.5625GBd
Differential pk-pk input voltage tolerance900mV
Differential termination mismatch10%
Module stressed input testPer Section 120E.3.4.1, IEEE802.3bs
Single-ended voltage tolerance range-0.43.3V
Common-mode voltage-3002800mV
Official English source table
ParameterSymbolMinTypicalMaxUnitsNotes
Transmitter
Center Wavelengthλc840850860nm
RMS Spectral width∆λ0.6nm
Average Launch Power, each lane-6.2-4dBm
Optical Modulation AmplitudeOMA-4.2-3dBm
Launch power in OMA minus TDECQ-5.6--dBm
Average Output Power (Laser Turn off)---30dBm
Extinction RatioER3--dB
Transmitter and dispersion eye closure (TDECQ), each laneTDECQ--4.5dB
TDECQ – 10log 10 (Ceq ), each lane4.5dB
Optical Return Loss ToleranceORLT--12dB
RIN12 OMA-128dB/Hz
Encircled flux at 4.5μm30%
Encircled flux at 19μm86%
Receiver
Center Wavelengthλc840850860nm
Damage threshold5--dBm
Average receive power, each lane-8.44dBm
Receive power, each lane (OMAouter)-3dBm1
Receiver sensitivity (OMAouter), each laneRx_sen-6.5dBm1
Official English source table
ParameterSymbolMinTypicalMaxUnits
LOS AssertLOSA-20--dBm
LOS De-AssertLOSD---9dBm
LOS HysteresisLOSH0.5-5dB
Official English source table
ParameterSymbolAccuracyUnitsNotes
Transceiver Case TemperatureDMI_TEMP±5°COver operating temp
Supply voltage monitor absolute errorDMI _VCC±3%VFull operating range
Channel Bias current monitorDMI_IBIAS±3%mAPer channel
Channel RX power monitor absolute errorDMI_RX±3dBPer channel
Channel TX power monitor absolute errorDMI_TX±3dBPer channel
Official English source table
Data RateFactorOpticalWavelengthReach
200GQSFP56SR4MPO850nm100m
Official English source table
Rev.CommentsAuthorDate
A01Initial ReleaseJames Chen10/01/2023

FW-087 Product Notice

This product belongs to the F-tone Networks FW-087 series. For detailed information, please contact our sales team.

Important Notice

Performance figures, data and any illustrative material provided on this page are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement, specifications may change without notice.

The publication of information on this page does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.

Contact Us

For pricing, datasheets and OEM/ODM inquiries, contact the F-tone Networks sales team: betty@f-tone.com / una@f-tone.com · WhatsApp: +86 17360698946 (Betty), +86 17761163895 (Una)