100G SFP28 SR4 Transceiver
F-tone Networks 100G SFP28 SR4 Transceiver. Application • Data center & Networking Equipment; Features • Compliant to QSFP28 MSA; Product Specification Absol…
- Application
- • Data center & Networking Equipment
- Features
- • Compliant to QSFP28 MSA
- Product Specification
- Absolute Maximum Ratings (TC=25°C, unless otherwise noted)
- PIN Descriptions
- Figure 1 – Pin Definitions
- ESD Safety Cautions
- This transceiver is specified as ESD threshold 1KV for high speed data pins based on Human Body
- Important Notice
- The performance figures, data, and any illustrative material presented in this datasheet are typical and must be explicitly confirmed in writing by before they are deemed applicable to any specific order or contract.
Reference model FW-087-100G-SFP28-SR4-TRANSCEIVER in your inquiry. Datasheets are confirmed offline before order. Full specifications ↓
Technical parameters
| Application | • Data center & Networking Equipment |
|---|---|
| Features | • Compliant to QSFP28 MSA |
| Product Specification | Absolute Maximum Ratings (TC=25°C, unless otherwise noted) |
| PIN Descriptions | Figure 1 – Pin Definitions |
| ESD Safety Cautions | This transceiver is specified as ESD threshold 1KV for high speed data pins based on Human Body |
| Important Notice | The performance figures, data, and any illustrative material presented in this datasheet are typical and must be explicitly confirmed in writing by before they are deemed applicable to any specific order or contract. |
| Model | 100G SFP28 SR4 Transceiver |
Product details
• Compliant to QSFP28 MSA • SFF-8636 Specification • Wide Operating Temperature(0°C~70°C) • 4x25Gbps and 4x27.95Gbps 850nm VCSEL-based Transmitter • RoHS compliant
Official English source features include: •.
Applications listed on the official English page: •.
Parameters and any table below are taken from the official English source page and are typical values only. The inquiry code on this page is an inquiry code, not a confirmed factory part number.
| Parameter | Symbol | Min | Typical | Max | Unit | Notes |
|---|---|---|---|---|---|---|
| Storage Temperature | TS | - 40 | - | +85 | °C | |
| Maximum Supply Voltage | Vcc | - 0.5 | - | 3.6 | V | |
| Operating Relative Humidity | RH | 0 | - | +85 | % | No condensation |
| Parameter | Symbol | Min | Typical | Max | Unit | Notes |
|---|---|---|---|---|---|---|
| Operating Case Temperature | Tc | 0 | 70 | °C | C- Temp | |
| - 40 | 85 | °C | I- Temp | |||
| Power Supply Voltage | Vcc | 3.15 | 3.3 | 3.45 | V | |
| Power Consumption | 3.5 | W | ||||
| Lane Baud Rate | BR LANE | 25.78125 | Gbps | |||
| 27.9525 | Gbps | |||||
| Bit Error Ratio | BER | 1E- 12 | ||||
| Data Speed Tolerance | ∆DR | - 100 | - | +100 | ppm | |
| Operating Distance | D | 70 | m | @ OM3 MMF | ||
| 100 | m | @ OM4 MMF |
| Parameter | Symbol | Min | Typical | Max | Unit |
|---|---|---|---|---|---|
| Center Wavelength | λ | 840 | 850 | 860 | nm |
| RMS Spectral Width | RSM | 0.6 | nm | ||
| Average launch power, each lane | Pf | - 8.4 | 2.4 | dBm | |
| Optical Modulation Amplitude (OMA), each lane | Tx OMA | - 6.4 | 3 | dBm | |
| Average launch power of OFF transmitter, each lane | - 30 | dBm | |||
| Extinction ratio | ER | 3 | dB | ||
| Optical return loss tolerance | 12 | dB |
| Parameter | Symbol | Min | Typical | Max | Unit | Notes |
|---|---|---|---|---|---|---|
| Center wavelength | λ | 840 | 850 | 860 | nm | |
| Damage threshold | 3.4 | dBm | ||||
| Receiver sensitivity (OMA) | S OMA | - 7.2 | dB | BER@5E- 5 | ||
| Receiver reflectance | - 12 | dB | ||||
| LOS Assert | LOS A | - 30 | dBm | |||
| LOS De- Assert | LOS D | - 10.5 | dBm | |||
| LOS Hysteresis | LOSH | 0.5 | dB |
| PIN | Logic | Symbol | Name/Description |
|---|---|---|---|
| 1 | GND | Ground | |
| 2 | CML- I | Tx2n | Transmitter Inverted Data Input |
| 3 | CML- I | Tx2p | Transmitter Non-Inverted Data output |
| 4 | GND | Ground | |
| 5 | CML- I | Tx4n | Transmitter Inverted Data Input |
| 6 | CML- I | Tx4p | Transmitter Non-Inverted Data output |
| 7 | GND | Ground | |
| 8 | LVTTL- I | ModSelL | Module Select |
| 9 | LVTTL- I | ResetL | Module Reset |
| 10 | VccRx | + 3.3V Power Supply Receiver | |
| 11 | LVCMOS- I/O | SCL | 2-Wire Serial Interface Clock |
| 12 | LVCMOS- I/O | SDA | 2-Wire Serial Interface Data |
|---|---|---|---|
| 13 | GND | Ground | |
| 14 | CML- O | Rx3p | Receiver Non-Inverted Data Output |
| 15 | CML- O | Rx3n | Receiver Inverted Data Output |
| 16 | GND | Ground | |
| 17 | CML- O | Rx1p | Receiver Non-Inverted Data Output |
| 18 | CML- O | Rx1n | Receiver Inverted Data Output |
| 19 | GND | Ground | |
| 20 | GND | Ground | |
| 21 | CML- O | Rx2n | Receiver Inverted Data Output |
| 22 | CML- O | Rx2p | Receiver Non-Inverted Data Output |
| 23 | GND | Ground | |
| 24 | CML- O | Rx4n | Receiver Inverted Data Output |
| 25 | CML- O | Rx4p | Receiver Non-Inverted Data Output |
| 26 | GND | Ground | |
| 27 | LVTTL- O | ModPrsL | Module Present |
| 28 | LVTTL- O | IntL | Interrupt |
| 29 | VccTx | +3.3 V Power Supply transmitter | |
| 30 | Vcc1 | +3.3 V Power Supply | |
| 31 | LVTTL- I | LPMode | Low Power Mode |
| 32 | GND | Ground | |
| 33 | CML- I | Tx3p | Transmitter Non-Inverted Data Input |
| 34 | CML- I | Tx3n | Transmitter Inverted Data Output |
| 35 | GND | Ground | |
| 36 | CML- I | Tx1p | Transmitter Non-Inverted Data Input |
| 37 | CML- I | Tx1n | Transmitter Inverted Data Output |
| 38 | GND | Ground |
| Parameter | Symbol | Accuracy | Units | Notes |
|---|---|---|---|---|
| Transceiver Case Temperature | DMI_TEMP | ±5 | °C | Over operating temp |
| Supply voltage monitor absolute error | DMI _VCC | ±3 | % | Full operating range |
| Channel Bias current monitor | DMI_IBIAS | ±10 | % | Per channel |
| Channel RX power monitor absolute error | DMI_RX | ±3 | dB | Per channel |
| Channel TX power monitor absolute error | DMI_TX | ±3 | dB | Per channel |
| Data Rate | Factor | Optical | Wavelength | Reach | |
|---|---|---|---|---|---|
| 100G | QSFP28 | SR4 | MPO | 850nm | 100m/300m |
| Rev. | Comments | Author | Date |
|---|---|---|---|
| A01 | Initial Release | James Chen | 10/01/2023 |
FW-087 Product Notice
This product belongs to the F-tone Networks FW-087 series. For detailed information, please contact our sales team.
Important Notice
Performance figures, data and any illustrative material provided on this page are typical and must be specifically confirmed in writing by F-tone Networks before they become applicable to any particular order or contract. In accordance with the F-tone Networks policy of continuous improvement, specifications may change without notice.
The publication of information on this page does not imply freedom from patent or other protective rights of F-tone Networks or others. Further details are available from any F-tone Networks sales representative.
Contact Us
For pricing, datasheets and OEM/ODM inquiries, contact the F-tone Networks sales team: betty@f-tone.com / una@f-tone.com · WhatsApp: +86 17360698946 (Betty), +86 17761163895 (Una)
More in Optical Transceivers
MTP-16 OS2 Elite Trunk, 16 Fibres, 1m
View details →800G OSFP224 Passive Twinax DAC, 1m
View details →
MTP-12 OS2 Elite Trunk, 12 Fibres, 1m
View details →MTP-16 OM4 Elite Trunk, 16 Fibres, 1m
View details →
MTP-12 OM4 Trunk Cable, 12 Fibres, 1m
View details →MTP-12 APC OM4 Trunk, 12 Fibres, 1m
View details →
MTP to 4× LC UPC OM4 Breakout, 8F, 1m
View details →MTP to 4× LC UPC OS2 Breakout, 8F, 1m
View details →MTP to 12× SC UPC OS2 Breakout, 24F, 1m
View details →MTP to 12× LC UPC OS2 Breakout, 24F, 1m
View details →MTP to 12× SC UPC OM4 Breakout, 24F, 1m
View details →MTP to 12× LC UPC OM4 Breakout, 24F, 1m
View details →MPO-8 APC OS2 Elite Trunk, 8 Fibres, 1m
View details →